Wednesday 17 April 2013

hey there again internet, its been a long couple days working on the power supply. i've built one already, but it hasnt worked because 1. my board design was flawed and 2. one of the 7805's was defective (naturally) anyways so ive designed and printed off a new board. this one is double layer, its only the second two layer board ive make and i'm pretty proud of the alignment on it. i've also figured out the magsafe pin configuration and applied that to the new board.

pics below of my progress, stay tuned!
(the values on this one are wrong for the 317 circuit just a heads up)

ps: tomorrow ill post more pics of the board (assuming this one works)

No comments:

Post a Comment